401 on a concept 30

[geerbangr]

I could use a 401 gyro on a concept 30 could'nt I ??

[kraaijer]

Sure you can... Why would you think you can't?

[BarracudaHockey]

Thats a wire drive tail, it can get backlash and cause some strange behavior when that wire starts unloading.

[Maxx26]

I think you have to run in nonheading hold (normal mode) so you dont snap the wire :?: I could be wrong though

[capebob]

It will work OK unless you turn the gain up too far. With the gain up too high the wire will tend to twist and cause a rather severe tail wag. Go easy on the gain and it will work.
Bob

[Tugrul]

It will work OK unless you turn the gain up too far. With the gain up too high the wire will tend to twist and cause a rather severe tail wag. Go easy on the gain and it will work.
Bob

I would replace the wire with a shaft. Use 4-5 mm carbon rod or arrow shaft. Get help from a friend with machining capability to tailor make/convert the end pieces.