Finalized my build list, going to order today, Anything I missed?

[Gadflyii]

Well after lots of thought, I have decided to go ahead and pull the trigger. I seriously thought about going after some high dollar gear, but decided to keep the cost down as much as possible, and use some of the equipment I already have on hand.

So I thought I would post my list here for a last min. Sanity check, to be sure I am not making any obvious mistakes.

2x Savox SC-1257TG Digital Servos (Algin DS620) $55 each (Already own 1 brand new servo)
1x Savox SH-1290MG (Align DS650) Digital Tail Servo $63
1x Hobbywing Plat Pro 120HV ESC w/ Software and USB: $155
1x Sk720 w/ power bus (already own it)
1x WR Super BEC $99

Total electronics cost: $422

4x Turnigy 6S 5000 35C packs (USA wharehouse): $70 each

Total Lipo cost: $280

1x 7HV w motor and CF blades: $739

Total Cost: $1441

:thumbup:

Really excited about this heli!

[uragano47812]

All ok i think. velcro straps for batteries? i prefer Mikado one over the stock but this is only a little point.

If you find buy KBDD Extreme 104mm tail blades. The one included is ok but i don't know if they are rigid as Extreme edition.

[Diviner]

I recommend some caps for the tail pins. Unfortunately they are in other parts, not sold alone.

My pin slipped after oiling and caused $300 + of damage. If you have some older packaged tail grip linkages, you can borrow from there.

Or order tension pins from McMaster Carr.