CCPM hook up servo's

[helihenk]

Hi ,

I know it's been here some time ago , can't find it .

When using CCPM on the T14 there were 3 receiveroutputs you could use
wich got there pulse at excatly the same time .

Anyone know where to find it ?

Henk

[DavidH]

Look at the function list in your TX. That is the order you want to plug the servos in the RX. Starting at the top of the list in channel 1.

David

[helihenk]

Yes I know how to hook up the servo's , thats not the question .

Only for CCPM use there are 3 outputs on the receiver that work exactly
at the same speed .
Thats what I need to know .

Henk

[RCfan]

What David meant was to look at the channel layout in a default heli model, that's already setup to take advantage of channel grouping. That is, aileron, elevator and pitch are all grouped in channels 4-6. Doesn't matter if you're using CCPM or not, the grouping exist at all times. There are 4-such groupings you can use 1-3, 4-6, 7-9, 10-12.

It's described in the manual:
Note: In PCMG3 mode, combinations of three
channels such as CH 1 through CH 3, CH 4 through
CH 6, CH 7through CH 9 and CH 10 through CH 12
work simultaneously. Futaba recommends that you
use the standard optimized default combinations
of channels and functions in order to minimize
servo delay when you use multiple servos to control
models such as swash mode helicopters and dual
elevator airplanes or fl aperon airplanes.

Also see FAQ: http://www.14mz.com/faq/faq-14mz-q806.html

[harryboe]

Is there a similar function for the 12z.
I have not found any note in the manual ?


Thanks

[DavidH]

Yes there is the same function in the 12Z.
Turn on the TX.
Then select the Linkage menu
Then Scroll down to Function and open up that menu.

The channels and what there Function , listed in order.
CH 1 Throttle
CH 2 Rudder
CH3 Gyro

CH 4 Aileron
CH 5 Elevator
CH 6 Pitch/Collective

CH 7 Governor
CH 8 Governor
CH 9 Aux1
CH 10 Aux 2
CH 11 Aux 3
CH 12 Aux 4

That is the default order for the channels in 12Z. That is the order I use no matter which receiver I am using. G3, 1024 PCM, PPM.

David