Micro Heli Blade Balancer?

[HeliHulk]

Hello everyone I am new to the site. I have been calling my local hobby store asking for a Micro Heli Blade Balancer for Blade CP and everyone answer me like if I were asking for something that is not from this planet. I had a guy told me wow you want that. I have not been ask for that in 3 years. I told him well it is very important to balancer the blade for the Heli to perform well. Is this not in use anymore?? Are the new blade already come balance from factory???

Whats a good blade balancer that does micro Heli and bigger till 30??

Thanks for the Help..

[LITHIUMSTATIC]

Seriously I just add a little tape on the end and spool it up and see if the head shakes or not. Move a little tape on the other blade and see what happens. You can get it really smooth just trial and error method. Been doing it that way for 2 years on the Blade CP... My my E-620 is different and I use a K&J balancer for that.

[Pinecone]

I check and adjust the CG of the blades first, then weigh them on a scale that goes to 0.1g. I adjust wieght to match and no problems.

[LITHIUMSTATIC]

Just run a bolt through them to make a see-saw and check it that way. It's simple and fast. Pincones way is best though.

[vteknical]

Check out Bob Finless's T-rex SE build videos. There is a blade balancing specific video. That should pretty much get you in the right direction.

[Pinecone]

The problem is, there are no balancers made for 2mm hole blades. The closest is the Helimax which has 2.5mm pins.

[HeliHulk]

Check out Bob Finless's T-rex SE build videos. There is a blade balancing specific video. That should pretty much get you in the right direction.

Got it Vteknical you where right I should have look at the website better found what I was looking for..


Thanks