Kyle2Baseball
11-29-2004, 08:34 PM
have a Venture 50 and I have flown 2 gallons through it with Heli Tech Carbon Blades which are on the heavy side with no problems. Through the 2 gallons I had done some mild 3D and then started doing tic tocs. Then I got a set of MAH Blades the very first flight with them all I did was some tumbling and some tic tocs and the clutch went out. After replacing the clutch I flew one flight with some hard 3D ( tic tocs piro-flipping chaos and lots of tumbling with no problems. Then the next flight I did some flying around with some tumbles and I belive the clutch went out again, it might of been the one way but the engine zings up real high while not going anywere just as the first time. So I have had three flights with the MAH Blades and 2 clutchs bad. Is it possible that the lighter blades made the helicopter work harder by not having the energy that the heavier blades had? I really hope that the blades arnt the problem. And the clutch was aligned right. Do u have any suggestions for a better clutch. I was thinking about getting a new clutch and taking the lineing out and putting the raptor 90 clutch lineing in.