PDA

View Full Version : Bantam 902 Gone Crazy


Racer38
04-28-2007, 05:20 AM
Lots of problems...

I got the 902 and charged about 5 times on it, then today I heard something pop. Checked the fuse on the V Balance module and it was blown. Replaced the fuse and it immediately blew, I was thinking it was the Balancer. So I hooked up a RX pack that needed to be charged and it melted the wires before I could get it turned off, so there is definately a problem with the charger. I then tried to use the balamcer on my Astro 109 and it doesnt work, the minute you hook the battery up it goes into charge mode without even hitting the link button.. So basically I am guessing this new charger is smoked along with it smoking my balancer as well. Now I'm dead in the water.....

Leaving on mission for a week as well so I wont even be able to take care of warranty stuff till I get back, and as long as it takes to get stuff over here I might just as well ship everything home and GIVE UP .. I HATE THIS PLACE ( IRAQ ).....

CYA Craig :arggg:

RC Accessory
04-28-2007, 06:27 AM
Craig, sent you an email.