esky belt cp

[kepp]

Hi all.
Am new to electric helis and have bought a esky belt cp It comes complete with everything except a TX in which I have already a jr x3810.
I substituted the rx for a r700 reciever i had. I have a couple of questions .I have installed servos and gyro into these positions
1 Throttle -ESC
2.AILERON
3.ELEVATOR
4. RUDDER-Gyro
5. --
6. Aux1-PITCH
7. --
Is this correct ?
Also what pitch and throttle curves should I have?
My radio supports 5 point curves as 0-1-2-3-Hi.
And why when I increase the 0- pitch curve does the motor start.
Thankyou Kepp

[Flip465]

Hi Kepp,
I've just started electric helis also, and was trying to find out if I could use my JR 388S Tx and either its R770S slimline Rx or R610M micro Rx to put straight into a new Esky Belt CP Barebone kit that I just found in an on-line shop in Hong Kong.
I've been told, by the local 'experts' that JR gear will / will not work with Esky servos, etc. Half said it will, half said it won't.
All that missing from the full Belt CP kit is the Tx, Rx, battery and charger.
Price - Aus $ 155 plus another $38 for Express Post with tracking.
Going to order it now after finding this site and the information about Esky & JR.
Thanks to all of you and all the others here for the information.
Flip.
Perth W.A..