Esky belt CP

[kepp]

Hi all.
Am new to electric helis and have bought a esky belt cp It comes complete with everything except a TX in which I have already a jr x3810.
I substituted the rx for a r700 reciever i had. I have a couple of questions .I have installed servos and gyro into these positions
1 Throttle -ESC
2.AILERON
3.ELEVATOR
4. RUDDER-Gyro
5. --
6. Aux1-PITCH
7. --
Is this correct ?
Also what pitch and throttle curves should I have?
My radio supports 5 point curves as 0-1-2-3-Hi.
And why when I increase the 0- pitch curve does the motor start.
Thankyou Kepp

[millburn]

Hi Kepp,

I also have setup a JR R700 receiver in my Belt CP. The channels you list are the same as mine which seem fine on my JR x-378 Tx.

I had to reverse rudder and aileron channels.

To start off I have a linear throttle curve and a pitch curve of -
0, 25, 50, 75, 95

I've only just started playing with my Esky Belt CP, I've found so far that the Swash Plate is a bit high when all servo's at 90'. I also need to set the tracking as one blade is a bit low when it's light on the skids.

Private Message me if you like.

Cheers.

Hi all.
Am new to electric helis and have bought a esky belt cp It comes complete with everything except a TX in which I have already a jr x3810.
I substituted the rx for a r700 reciever i had. I have a couple of questions .I have installed servos and gyro into these positions
1 Throttle -ESC
2.AILERON
3.ELEVATOR
4. RUDDER-Gyro
5. --
6. Aux1-PITCH
7. --
Is this correct ?
Also what pitch and throttle curves should I have?
My radio supports 5 point curves as 0-1-2-3-Hi.
And why when I increase the 0- pitch curve does the motor start.
Thankyou Kepp