View Full Version : Align 600L on Logo 10 3d?
What do you think about align 600L on logo 10 3d ? ( for battery I will use 6s1p 3700 )
bye
cptsnoopy
05-03-2007, 04:08 AM
Here is a short thread I started about this.
http://www.helifreak.com/viewtopic.php?t=21651
Here is a short thread I started about this.
http://www.helifreak.com/viewtopic.php?t=21651
Ok, now do you fly with align setup ?
Do you test align setup again ? Do you refine it ?
What's good setup according to you ?
Bye
cptsnoopy
05-03-2007, 01:50 PM
I have not used the align setup since I took it off last November. The setup I am using now is here: http://www.helifreak.com/viewtopic.php?t=27154 posted on Fri Apr 20, 2007.
I would try the Align setup again using the batteries I have now (4 TPX 3s-2070) in a 6s-2p config and run the headspeed up to 2200. That way the 13tooth pinion should put the motor closer to its best operating rpm. That was a 13t pinion with the 200t main gear. This was using the 550mm main blades. If your using the 500mm blades the system may even work better and last longer. I will not be trying this again soon (I hope) as the system I have now rocks just fine. If you have not purchased a motor yet, I have heard good things about the Z-power Z30-1100 in a logo10 but I have not tried it myself.