Blade CP pro with heading hold gyro

[robl]

well some of you may know I am having slight issues with my "guaranteed to fly out of the box" heli from ebay. I have put on a telebee heading hold gyro and a new tail motor and finally it will fly.

But, if I turn up the sensitivity, it wags, if I turn it a little lower then it doesn't really hold. Does the stock tail just really suck this bad?

I tried doing a piro and it crashed. It started really slow and then started spinning really fast. I'm going to try it again tomorrow I suppose but don't know if I should just wait for a direct drive motor. Its really frustrating. The walkera 52 was easier to fly than this thing.

[txflyer]

egh wait for the dd... go get a sim in the mean time

[robl]

I have a sim, and two trexes, a mini zoom and no problems with them. This thing is a nightmare.

I forgot to ask, is it normal for it to barely climb? I have like 12 degrees of pitch at full positive.

[txflyer]

wow dude. id get my money back on it asap. something isnt right for it to be barely climbing. if i punch my throttle to full throttle it would take maybe 2 or 3 seconds to reach a telephone top.

[robl]

well its the normal stock motor, it came with flat bottom blades, those are supposed to create more lift. I'm guessing the motor is probably dead. I'm planning to go brushless in it. But really, this is a ripoff, the guy won't reply to my emails and ebay's system is so broken that I can't leave him bad feedback without getting it myself.

[txflyer]

dont leave feedback. open a conflict thing on ebay and with paypal

[robl]

yes, maybe I should do that. I will look into it, would like to give him a chance to respond first in email.