Lama v4

[nicolasmit]

I can't seem to get my new lama v4 4 in 1 controller to initialize properly. When I plug in the battery, the controller flashes green-red-green-red, non stop. My tx is on with the throttle stick at zero. Any ideas or help greatly appreciated.

[ped]

I can't seem to get my new lama v4 4 in 1 controller to initialize properly. When I plug in the battery, the controller flashes green-red-green-red, non stop. My tx is on with the throttle stick at zero. Any ideas or help greatly appreciated.

Hi
if no one has yet sorted you out. Make sure that the "reverse sw|'. are the correct way.

If they are then one of them is still reversed I had this problem on a CP2 and it was a Sw that reqd. rexersing even though the manual said otherwise.

Look at Heliguy.com forums

cheers

Peter

[davidnyuspri]

You need to lower the throttle and trim to the bottom, refer to this picture: http://www.china-magic3.com/picture.php?cat=45&image_id=370

[Licorice93]

I can't seem to get my new lama v4 4 in 1 controller to initialize properly. When I plug in the battery, the controller flashes green-red-green-red, non stop. My tx is on with the throttle stick at zero. Any ideas or help greatly appreciated.

Hey mate i had the same problem with my lama extreme and futaba 6exh i found out that it was because i had the PCM mode on. when i switched to PPM then it worked.. try reading your manual to see how you switch it.

Good luck.