PDA

View Full Version : Plash board and memory questions.


dragonflyer
11-13-2011, 02:21 PM
1. What is the "plash board"? When and where do we need it?

2. On YouTube " http://www.youtube.com/watch?v=eaXLuSrvc5Y " we are told to turn both heli and transmitter ON during transmitter configuration. Why does the heli power need to be ON?

Thank you.

Miami Son
11-13-2011, 02:31 PM
More of a transmitter question than a 450 one, but I'm guessing that there is some interfacing going on between the Tx and the Rx during programming.

TowPilot
11-13-2011, 02:51 PM
These links may help;

http://zapumal.info/?p=65

http://www.mycoolheli.com/t6config.html


Mike

dragonflyer
11-13-2011, 04:21 PM
These links may help;

http://zapumal.info/?p=65

http://www.mycoolheli.com/t6config.html


Mike

I am OK with the sw installation and the connection between the transmitter and PC.

The way I understand it, there is no memory on the heli. We can turn it ON and physically adjust the servos after the configuration is saved on the transmitter by turning it OFF then ON again. Please correct if I am wrong.

I only would like to understand why the heli power has to be ON during the configuration. :thumbdown:
Lam