PDA

View Full Version : dx8 elevator always -1 in expo/DR screen


Elliott000
11-27-2011, 09:44 PM
Ive been having an issue with me choppers both my trex's 450 FB and 550 FBL having slight backward drift. Found in my DR/expo screen on ele channel i have a consistent -1 on the output.... preoblem found but how do i fix this? im runnin airware. 1.04 or whatever the newest is!

thanks

Slyster
11-27-2011, 10:12 PM
thats normal. I think 3 of my channels say -1. But they ALWAYS say -1 which is the good part. But if you think that could be the issue (might be?) you can calibrate the sticks and that should fix it. I haven't done it, but I know its in the manual and in the menus.

wanderer56
11-29-2011, 06:25 AM
Use a blank channel without any sub-trims, trims, etc.linear pitch and throttle curves. Rx does not have to be on. Do the stick calibration, then switch back to the original model and see if that works.

Elliott000
11-29-2011, 10:17 AM
Did a stick cal and got it sorted

Sent from my GT-I9100M using Tapatalk