Braided sleeving for your wires (Blue, Red & Black)

[Flying glass]

I have 1/8 & 1/4 non fray black PET sleeving & 1/4 red & blue standard PET sleeving for sale.
A great way to clean up and protect your wiring on your helicopter.

The black (both sizes) is .65 per foot plus shipping
The red and blue are .95 per foot plus shipping
Shipping is $2.00
normally able to ship same or next day

***I am out of the 1/8" non-fray black for now***

[Ninjak2k]

For what application do you recommend each size of the sleeving? What would you recommend for normal servo wire?

Thanks,
Dan

[hydroman]

I have used the 1/4" on standard wire....

[txflyer]

i plan on using the 1/4 on my motor wires and power wires, then 1/8 on servo wires.

[edwardrichardson]

I have 1/8 & 1/4 non fray black PET sleeving & 1/4 red & blue standard PET sleeving for sale.
A great way to clean up and protect your wiring on your helicopter.

The black (both sizes) is .65 per foot plus shipping
The red and blue are .95 per foot plus shipping
Shipping is $2.00
normally able to ship same or next day

Hi,
I would like to purchase 5 feet of each size in black. Do you accept paypal?
Thanks,
Ed

[Flying glass]

I do use PayPal, please just send a pm and I will get back to you with my PayPal ID.

As far as application goes, I typically use the 1/8" for 1 or 2 wires and the 1/4" for bundles of 3 or more.
I have been using the 1/4" for the ESC and motor wires as well as the gyro wires.
You can easily double up the gyro wires inside the sleeving if you dont want to shorten them.

I recently received a pm from a member wanting to know why if I was a dealer or (store) then why did I not just have a website.
I am not a store, dealer or anything else. When I went to buy this product for myself I found that it was difficult to locate and expensive to buy in small quantities. So to save myself some money I purchased a large quantity and have been passing these savings on to other modelers.
The money I make from these sales (and it's not much) simply stays in my PayPal acct. and is used when purchasing from other members and stores in this hobby.
Thanks
John

[Naja002]

I'm new to the hobby and don't have my bird yet---So, approx. how many feet of the 1/8" and 1/4" would be needed for a single 450SE v2?

I realize that You cannot really tell me exactly, but one person above ordered 5ft of each size. So, is 10ft a safe guess?

Thanx!

[txflyer]

i ordered 2ft of each. i still have enough left to pull off the heli. i think. this might help

i used a hair over 7in for each servo wire. that left about a half inch of exposed wire on the servo wire. i wanted it like that so that when it plugs into the rx, i wouldnt have the stuff bunching up. my esc wire that runs to the rx has 11in's of the sleeving on it. that leaves about the same amoutn as the servo wires exposed. i havent done the esc motor wires yet but those would be short. then i think that will leave me just enough for my tail servo. i hope that helps.

[always_rc]

Received mine a couple of days ago. Quick to ship and got exactly what I ordered. Thank You.