mSR x codes for dx6i

[Olyyy]

Can anyone help with the codes for a rookie?

[MikeTE]

Quite new to this myself but you could just look at the programming folks have used for their mSRs and use that as a starting point. I'm using the same programming on my mSR X as I use on the mSR and it's working great for me.

Basically I'm using 70% d/r and 30% expo on elevator and aileron. I left the rudder alone. This worked well to get me started with this heli, it is pretty quick so these settings softened it up nicely.

My throttle curve is 0%, 28%, 47%, 66%, 100%. Still tweaking that a little bit but it's pretty good for now.

[Fotofly]

Basically I'm using 70% d/r and 30% expo on elevator and aileron. I left the rudder alone. This worked well to get me started with this heli, it is pretty quick so these settings softened it up nicely.

My throttle curve is 0%, 28%, 47%, 66%, 100%. Still tweaking that a little bit but it's pretty good for now.


On my throttle curve I have N 1 2 H

did you make just one, all, or N1&2 all to those % ?

[My98stang46]

Here you go. Flies like a dream

[YoYo-Pete]

I was going to say, those are what I use too. :rotf Then I noticed the URL on the attachment.

I have to say I found this attached on the forums here... I dont know who created it. Works nice though.

Check this thread: http://www.helifreak.com/showthread.php?t=372477

Has the settings, the manual, and an official guide that is nice.