PDA

View Full Version : Servo connection, forgot which was which.


Vinno
01-06-2012, 06:55 AM
Hey guys,

I started to troubleshoot the servo's and found one was dead but in my haste i started pulling all the servos out and now i forgot which order they go into the receiver..

Can any one tell me the order of the servo wires to the receiver?

First slot is bind, what order is the front servo, top servo and servo right under that one?

Thanks in advance.

whoanelly
01-06-2012, 07:28 AM
typical is this ,,

throttle = ESC
elero = top left cyclic or right doesnt matter.
elevator = is front cyclic servo
Gyro= Gyro (3 wires)
gain = Gyro (one signal wire)
Aux1 or pitch = top right cyclic servo

Vinno
01-06-2012, 12:09 PM
Still kind of confused sorry lol.

Is there a blade 450 wiring diagram around with the stock receiver?

When you say top left, are we looking from the front or tail?

whoanelly
01-06-2012, 02:18 PM
looking from the rear of the Heli , but those two can be either or aleron or aux 1 ,it doesnt matter. ..what RX are you useing ? does it show channels or a list like i gave you ? if its channels then just go down the list i gave you starting with ESC is channel 1

if when you get it in and the back two are reversed from the setting that you have in your radio u can just switch the two

Scammer
01-06-2012, 08:54 PM
Hey guys,

I started to troubleshoot the servo's and found one was dead but in my haste i started pulling all the servos out and now i forgot which order they go into the receiver..

Can any one tell me the order of the servo wires to the receiver?

First slot is bind, what order is the front servo, top servo and servo right under that one?

Thanks in advance.stock setup

1. bind
2. Thro = ESC
3. Aile = Bottom servo or left when tail pointed toward you
4. Elev = front servo
5.Rudd = gyro
6. Gear = gyro (yellow single wire)
7.Aux 1 = top servo or right when tail pointed toward you

Vinno
01-07-2012, 12:19 AM
Thanks guys, Helped a ton :) where would i be without yous.