DX7, but where on earth is my gyro menu?

[felborn]

I got the DX7 Heli version, and im using it with a Align600 and a Futaba GY611. The gyro menu is missing, cant find it when im scrolling up and down, and it dont show when I using the list function. What on earth is going on :dontknow

Got the red plug in the Gear plugg, other in Rudder. Rudder moves as it should do, gyro seems to be working as well.

[felborn]

Meh, get some sleep I think. needed to turn the gear setting to gyro, menu is there now.

[tppjr]

You have to have the Gear channel selected to "gyro" or you will not get the gyro setup in the menu. It will show up in the blank space on the second page that you have now.

Thomas

[Jermo]

go up to the Finless Bob Helifreak tech room and find my DX7 setup vid.

[Jan-DK]

Page 73

Input Select
The Input Select function is used to select the switch input for the gyro gain and the channel that will operate
the gyro gain.
[INPUT SELECT]
AUX2 GEAR
GYRO INH
INCREASE and DECREASE key
Press to enter
INPUT SELECT
Hold while turning on transmitter
To Select the Function for the AUX2 Channel
Press the DowN and SELECT keys simultaneously, then turn on the transmitter.
Press the UP or DowN key until the INPUT SELECT function appears on screen.
Press the SELECT key until AUX2 is highlighted.
Press the INCREASE or DECREASE key to select the desired function.
The Auxiliary 2 channel options are:
INH:
Inhibit is selected if the gyro function will not be used on the Aux 2 channel.
F.MODE:
In this mode, the AUX2 channel is controlled by the flight mode switch and three positions are available. Sub
trim and travel adjust is used to set the center and end points for each switch position.
AUX2:
The Auxiliary 2 switch controls the AUX2 Channel.
gYRO:
The gyro mode is selected if you want to use the Gyro Sensing (see page 91) for more detail. Selecting GYRO
under AUX2 assigns the gyro sensing program to operate use the AUX2 channel. In this case the gyro gain must
be plugged into the AUX2 (Channel 7) channel.