Need help with CP Pro

[HeliHolic]

Hello Everyone,

I need help. I have a CP Pro thats about 9 months old, I learned to fly on it.

A few months ago, I thought my LiPo's were going bad, at about 3/4 power the red/green LED on the 3-in-1 reciver would go from solid green to red at about 3/4 power. I got a new balancer/charger combo, and this week a new battery. I still get the same results even with the new battery. No full power... What could be wrong? I'm still new to electric heli's.

Thanks, Rick

[txflyer]

the light turns red at full throttle. check your throttle trims i have mine set for a hair above the center

[Mortificate]

I am really noobish but have you checked the pitch on your blades? The red light on my 3 in 1 goes crazy if the pitch on my blades is too much.

[Schlumph]

The light is supposed to turn red. Check it out on www.bladecprepair.com

[HeliHolic]

The Pitch is ok, it just does have enough to lift off before power cutback. The LED works fine, at plugging in battery, test, and gyro spin-up everything is fine, after a solid green LED and a normal power to rotors then at almost 3/4 stick (power) is when it starts to cut power, it never gets to full power. Trim tabs are at bottom. I have about 30 hours flying it, and this just started when I got it out after winter.

[HeliHolic]

I installed the brushless/ESC and , I went back to the brushed motor, 2 flights with the brushless/ESC and two broken tail booms. I guess the extra weight. but I got a new 3-N-1 and reinstalled the brushed motor I had one flight on, Flys like new.

[txflyer]

how is the brushless setup causing boom strikes ?

btw i see you have a micro mosquito. thats my rainy day heli if i ever get around to getting new blades..

[HeliHolic]

I was using a great planes 25a ESC, that may have been where the extra weight, I never checked how much, but I could tail it was more. Yea, the MM is a great little bad weather heli.