nitronuts
06-06-2007, 10:18 PM
Im mounting the cn12rxc motor using the stock motor mount and the motor wants to sit cocked, not straight, is it possible to use the stock mount or do I need the GWS mount? Also I thought I read I need to reverse polarity for this motor, is this true?
txflyer
06-06-2007, 10:23 PM
no solder psoitive to positve and neg to neg... you need to enlarg the main hole so the brass ring at the base of the motor shaft pokes through. then you need to very slighty enlarg a mounting hole. you will see when you line it up.. actually i think with my new tail motor mount. i didnt have to enlarg the hole for the screws.. but the center one does need to be enlarger.. you can do that with a sharp knife or something..
txflyer
06-06-2007, 11:33 PM
make sure to clean the burrs out of the housing