View Full Version : Anyone use the AP2000i with a DX7?
Randynlp
06-08-2007, 01:12 PM
Will this work? If so, how?
THanks
MarkWebber
06-08-2007, 05:23 PM
It does work. Here's a link to what Gary Goodrum did with his programming.
http://www.helifreak.com/viewtopic.php?t=31943
GGoodrum
06-09-2007, 02:31 AM
Yep, it works just fine. :)
Randynlp
06-09-2007, 02:55 AM
Does it still allow you to control the shutter or should that be controlled by the camera operator?
GGoodrum
06-10-2007, 12:02 PM
No, there's not enough channels to also do the camera shutter, and/or camera tilt/panning control. I use a DX6 for this, and a tray to hold both transmitters. I'm still trying to figure out if I want to move up to the 9-channel JR setup, or maybe wait and see how Futaba's plug-in modules work with my 14MZ, which has been collecting considerable dust, of date.
-- Gary
bladebreaker
06-10-2007, 11:44 PM
Hey, do you guys know how to set up the 401s gyro gain to be controlled from the aux 4 channel on the Spartan? I'm running low on chanels on my 9chp. I remember reading that it can be setup this way, but can't find the thread.
Tip
MarkWebber
06-11-2007, 05:23 AM
Tip (no pun intended :wink: )
Take the gain lead out of your rx, plug a servo in and note the arm position then, plug it into slot #4 on your AP2000i and adjust Trim 4 until it is back in that same position. You can now plug the gyro gain lead into slot #4 and your in business.