JR 7000T gyro and 8700G setup help

[t-rexn8]

Hello

I have setup the gyro according to the manual and I noticed the tail servo always slightly hunting around center. If you feel the servo output gear you can feel it moving back and forth a little. There is also a noise that is audible. I am worried that it may cause damage. I have setup countless futaba gyros and have never had this problem before. I hope I am just missing something.

Any help from some expereinced users would be so helpful.
Thanks.

[nando v. arnhem]

Hi,

I have the new JR G770T gyro with 8900G servo.
The servo is also a bit shaking on the ground, but this is completely normal.
Once the heli is in the air, the hunting should stop and the tail locks (I think the 7000T is working about the same as the 770T).

JR is using a bit diffrent sensor than Futaba.

Hope this helps a bit,
Nando