140 ccpm on stratus

[roy voss]

hi,

i just changed my ma stratus from 120 to 140 , using 9451 servos, i seem to be having a problem with interaction at high and low pitch when moving the cyclic stick. the pivot ball moves around more then i would like. when i set up the 120, i was able to mix it out in the swash detail section. when i try this with the 140 it does not seem to have any effect on it. not sure were to go from here, played with it a few hours here and there with little change. the bell cranks and servo arms are at 90 degrees, when i did the 120 setup , i used ben minor's instructions and it worked great, but it just does seem to work with the 140, any help or ideas would be great full.


roy

[heligio]

Hi Roy,

Just a question, did you change the servo limits from 135 to 155?

Regards,
Gio.

[roy voss]

Gio,

no i did not, it is a fresh program.


roy

[heligio]

Hi Roy,

Before you start in the swash detail section you should set the limits of the 3 swashplateservo's to 155 instead of 135, and leave the end points at 100 both ways. Try to get all linkages at 90 degree without subtrim, or almost without.
It will be possible for you to use much higher values in the swash detail section because the servo's limits be much further.
I hope this helps?

Best regards,
Gio.

[roy voss]

all that was done way before hand, i had it perfect with the 120. i found out later there was problem with that particular model program. i reset it and it seems to work fine now. some how the file was corrupted. do not how or why. all of my other model files work fine.


roy