EVO50 MP2

[Helodad]

look at what I had to do to get MP2 to fit I had to add washers to bottom bolt.Plus it was kind of hard to do. Did anyone else have to do this on there evo50. One more thing are you all running a pressure line to the pipe

[claysmith]

i didnt use a washer on mine, what is it for?

[Helodad]

the bolt that came with pipe to long hits frame. bolt came wtih Evo kit to short, So I used long one with washers.If it does not stay I will get the YS spacer.its just a pain to get the nut on the bolt. I know clay you one of the EVO gurues If you can give me your number I would like to talk I have a nextel and sprint cell phones

[claysmith]

Oh, Ok I see now, I just cut the bolt with a dremel to the correct length on mine. Screw the nut on and cut behind it so you wont damage the threads. It might take a couple tries to get the correct length. You can give me a call tomorrow if you'd like at 229-563-0538.

[Kinger]

Did the same thing on mine. Cut the bolt a bit and then held the nut with a pair of pliers while pushing the bolt through the engine. No biggie. As for the pressure line, yep I've got one installed right to the provided pressure nipple on the header.

[Duracizer]

I had the same problem, I just ground down the bolt a little using a bench grinder and then re-filed the beginning of the thread, fits like a charm.

[TerryBelanger]

I just went to Lowes and bought a bolt that fit.

The one I had fit fine. The threads on the pipe striped and I had the muffler come loose during flight. I lost the bolt so I just went and bought another one from Lowes. Since then I always run the pipes with bolts on them.