honey bee king 1 with RD 6000 super

[nabulaer]

hello,
I have been learning with HBK to hover and some basic FF. After watching Bob's videos about CCPM and adjustments I wanted to boost my control since I feel that the original Tx resolution is not that good. since I own RD 6000 for my trainer , I used it to the job.
the hbk is with original on board Rx and servos. I have reconnected the servos to the proper channels and adjust center points for swash pit.

my problem is that I think that the RPM of the main rotor is reaching a higher RPM then with the original Tx. is it possible for the ESC to actually produce that ? can I reach an RPM that can damage the motor ?


thanks for replies.

[nabulaer]

it looks like my THC and PC where off by using the defaults.

After watching Bob's videos again I have managed to set it better. the only thing is that after doing 15 of hover training the batteries are really hot , up to a burn level. Is that normal ?

[damyxz]

Adjust your throttle and pitch curve. Rule of thumb is that you need to let the rotor blades spool up to speed before you can introduce pitch. Introducing pitch prematurely will bog the motor down and produce heating of the motor and ESC.