Much better with the Align ESC!

[Azzurra]

Hi,

just when made up my mind to sell my H550 I just had this used Align 75 ESC. I soldered it and threw it in my bird.

- Soft Start isn's as soft as the GAUI ESC, but still OK. (I have a bad radio I just start with a switch)
- Governor works fine in 70% an 85% with 515 Blattschmied blades, equaling 1680 and 2040 RPM.
- Bogging is much less than the stock ESC.
- Motor still gets rather hot, much hotter than the 450F in the small Rex. But it's OK, if you stop afet 5 minutes.

I'm now running mid timing, maybe I'll experiment with high tomorrow.

Before flying my H550 I flew my brandnew Quick 50 Pro with a very rich enginge, to break it in. Maybe that's the trick: fly a weak nitro before, so you aren't disappointed with perfromance.
I spoiled it all with flying my T-Rex 450 SE afterwards, this is still my favorite, but let's see what's going on, when the .50 stinker ist working well!

best

Carsten

[X30PILOT]

I’m using the Align 75 amp controller on my stock motor. It is set on high timing. Set up this way I have more power than the stock controller with no increase in motor temp or amp draw.


X30

[Tom Viper]

Well, I got about a 60% decrease in power with the Align 75A and the Z power Z30A motor. Slow HS and lots of bogging. After I went back to the stock ESC, the power is back! Wow what a diffrence a ESC can do on diffrent motors. You would not belive the diffrence even if you saw it :shock:

I guess the Align 75A can make the same diffrence on other motors, but in a possitive way.