Dash
01-08-2005, 12:28 AM
This is my first heli build so please excuse the newbie questions.
I'm looking at Section I Building the Rotor Head. I have a question about step 1C. It says to align each flybar control arm until they are level with each other, then securely tighten each screw. Is just eyeballing it OK to get it level or is there a more precise way to do this? Should I apply loctite to socket set screws at this time as per the instructions or should I wait until I put the paddles on later in the manual and do the final alignment and apply loctite then?
I'm looking at Section I Building the Rotor Head. I have a question about step 1C. It says to align each flybar control arm until they are level with each other, then securely tighten each screw. Is just eyeballing it OK to get it level or is there a more precise way to do this? Should I apply loctite to socket set screws at this time as per the instructions or should I wait until I put the paddles on later in the manual and do the final alignment and apply loctite then?