jmdanna
04-14-2012, 05:00 PM
The only issue I had is the kde arms are not rebated to take the shouldered swash arm bolt.
can you explain this further? i dont understand what you're saying here
tshelby73
06-14-2012, 05:29 PM
Just did the upgrade. I already had the short balls on the inner swash and the longer ones on the outer. Also was on inner holes on servo arms. I had decent resolution but lots of cyclic ring in vbar, I was down to 69 cyclic ring and only 12 degree of pitch.
After KDE holder arm upgrade my resolution was in the high eighty's and low nineties with 13 degree of pitch and 78 on cyclic ring with no binding. I Used the KDE holder arms, outer holes on servo's, short balls on inner swash and long balls on outer.
Should be able to test tomorrow. I was just about to sell this hunk due to geometry but this may save it.
Troy