PDA

View Full Version : Spectra-G Tempest Blade mount problem...


Dash
01-08-2005, 03:27 PM
Well I just finished assembly the rotor head assembly. I then was going to temporarily install the two blade bolts, lock nuts and blade spacers. Thats when I saw that one of the machined blade mounts has both the top and bottom holes machined to take the hexagonal locknut :( Anyone else run into this problem? Can I use a dremel tool to smooth out the edges so the blade bolt will drop in or do I need to get a replacement blade mount?

ddavison
01-08-2005, 05:31 PM
If you are not in a hurry to get in the air, call them and send it back. If you are in a hurry there would be no problem I could see dremeling it out. Dave