reiserrob
06-21-2007, 02:54 PM
About 2 days ago I noticed the tail of my Raptor 50 Titan slowly drifting to the right, about 360 degrees/minute, The only thing I changed was the belt tension which I know will affect the mechanical linkage geometry, however, I was under the assumption that the gyro being in Tail lock mode, would compensate. When the problem persisted, I attempted to re-adjust the linkage and look over my radio settings just to make sure nothing was off. The problem is still there, doesn't matter, wind, no wind. Here are my gyro settings as read from the gyro programming menu, center trim (30), limits (108 & 108), mode (tail lock), 3D mode, servo (reverse), Receiver (JR), Gain (High), Gain set at 50% on gyro, about 75% on JR 9303, this gyro or servo has never been crashed and is relatively new. Heliproz told me all the obvious things to check. Is there a way to dump all info from the gyro and re-initialize? or is there something else I'm missing? And no there are no mixes on my radio i.e. revo mixing, and the tail is in perfect cond. all linkages fine. Please any info would be much appreciated..