slow piro razor

[busted blade]

my razors just dont seem to have the piro speed i would like. i have full throw on the ground and the only thing i can think of is the tail servo doesnt have enough balls in the air. razor #1 has 611 gyro/servo combo and razor 2 has 401 gyro/9254 servo. both have 16mm arms on the servos and both are on the outside hole on the tail.95mm v's, radix, and plastic blades all seem the same. its about 1-2 seconds for a full 360. any ideas? or is this just how it is

[mudbogger2]

what is your rudder atv or endpoints set at?

[buster1]

I am using the 601 and had the same problem - increased in ATV for Rudder and now where I want the piro. rate.

[busted blade]

yep, it was the end points. i have now idea why but at some point early on i set the end points to 54% :oops: for the life of me i cant remember why i would have set it there. anyway, all is well. thanks guys

[misskimo]

hey , I had a slow tail at first , then I noticed the brass slider was inserted the other way compared to this picture , it has a good piro rate now even at 2000 RPMs