ATG with 14mz need help !

[sookainian]

I need some help on this ATG with my 14mz.

I have follow the menual on setting up the ATG.

But during flight, when i am in idle-up 1, when i switch on the throttle hold, the engine wont go to hold.

But if i remove the ATG and plug the throttle directly into the Rx, the engine will go to hold when i hit the throttle hold siwtch.

I need help on how you set the throttle hold with ATG... ???

:dontknow

[R-4-L]

I don't know what your experiencing as I did not start the ATG yet.. been breaking-in the engine lately..

the manual doesn't go into details about 14mz/12z setup, so :

http://www.helifreak.com/viewtopic.php?t=39557

Just be sure that the Throttle Hold is the Top priority in the Conditions menu.

[MarkD]

Mine does the same with the GV1. If I disable the GV1 with a switch (Ch8) TH works in all idle up modes, but if the GV1 is enabled TH doesn't take effect. I've been :arggg: with this for a few months. I haven't yet tried to set the GV1 to disable when TH is active in the Govenor screen (weather has been pants for the last few weeks)

TH is at the bottom of the list (highest priority) in the condition screen. As I mentioned TH only takes effect if the GV1 isn't active

[sookainian]

R-4-L:
Yap, i actually did a search and saw that post. The same step as what the menual say.

Ok i will try to set TH to Top priority. And try it tmr or this weekend.

MarkD:
I also got a GV1 last time. When GV-1 is on, i hit TH, but it wont hold.

Then how do i set it ?

Can i set like TH + ATG off in a single switch ? But how ?

[sookainian]

i have tried putting it at the bottom of the list (highest priority). But the TH still cant work. Anyidea how to set ?

:arggg:

[pilou2]

I don' know for the ATV but with a governor GV1 and a 14MZ you need to set the governor "on" (governor menu) in every condition. The rate should be 0% for TH condition or whatever condition you don't want the governor to be active.
If you go to a condition where nothing is set for the governor it seems it will stay in its precedent state...

Not sure at 100% of this but I hope it is your solution. :)

[sookainian]

Btw thanks for your help i have solve it. :D

It is because i never set the throttle hold in the Throttle Hold Menual haha :mrgreen:

[Seeker]

Btw thanks for your help i have solve it. :D

It is because i never set the throttle hold in the Throttle Hold Menual haha :mrgreen:

I had the same problem but in reverse... I had set TH in the TH menu and assigned a switch... but I never created a condition for it. It worked and held priority but didnt show it was changing to the TH condition on the menu... :arggg: