Rotorworkz G10 Stock Frame Replacement Panel

[uragano47812]

Hello i'm building a new trex600 with 8s setup with Neu 1910H motor.

I know that i must modify my CF for the motor...

But i see that Rotorworks make cheap Stock Frame Replacement Panel G10 and i see that it has more space for the motor.

Will 1910H fit without any modification?

And the bearing on the frames (for the control levers) are included or i must use mine from original CF panels?

Let me know thanks

[JesusFreak]

Not sure about the 1910 fitting, but the frames are just frames. You will also need the bearings from your stock frames.

Regards,
Lee

[uragano47812]

Ok i have ordered the HFX :mrgreen:

[PDC]

I am considering the rotorworkz G-10 frame aswell as I want to install a Actro 24-3 motor and dont know if it is a good idea to just cut the Align CF frame.

Will two G-10 sideframes do the job alone?

Thanks!

[Ticidytoc]

Yes the 1910 will fit in the G-10 replacement frames. Just about any motor that will clear the lower frame tray will fit.

[PDC]

Thanks TT!

I will get a set of those then as a beginning :-).......can see I have to look a little closer into the RW frames as the high CG frames look interesting aswell.

[Ticidytoc]

The new HFX kits are really worth the money, there are alot of new parts to the kit. You are left with only 2 original Align frame parts after your done, not counting screws ofcourse. :mrgreen:

[PDC]

:-) sounds good, then we just need to have all the original standard screws replaced with hex screws for my screwing machine....then a frame replacement can be done really fast.

Maybe hex screws are included in the kits?