PDA

View Full Version : Naza VU bec voltage output


Twister773
03-25-2012, 10:46 PM
What is it? Looking to get servos ordered tonight for my f450 and really don't want to run a seperate bec unless I have to.

Tahoe Ed
03-25-2012, 10:51 PM
Per the Naza specs, 4.8-5.5v for voltage to the MU and therefor to your gimbal servos. I use s separate BEC and drive the servos at 6v. The CC 10A bec is not that large and is programable.

robi1kenobi
08-04-2012, 06:32 PM
I want to use CC 10A BEC too, do I have to remove red wire from Naza VU or can I just connect CC BEC to my receiver without any modifications?

Adidas4275
08-05-2012, 09:01 PM
I would just use the signal wire from the NAZA and power the servos off a BEC.....

Twister773
08-05-2012, 09:10 PM
I would just use the signal wire from the NAZA and power the servos off a BEC.....

X2. I've come a long ways since this thread started lol

robi1kenobi
08-06-2012, 05:00 AM
OK, I'll just disconnect '+' wire from VU, thanks for the help guys :)

sjgusmc21
08-09-2012, 01:25 PM
I too would like to try this. Although apparently not as smart or advanced as many of you here.....so anyone have diagram on this type of setup? Naza/CC Bec/Servo's? Thanks.