Hurricane 550 XES Pro SE NOT OFFSET LIKE THE REST

[aaronmatlo]

Just found out today that even though the cnc bellcranks on the Hurricane 550 XES Pro are setup for offset the rear elevator is not, not a problem just move the balls on the front two so they are not offset because out of the box they are.

also if your buying the custom carbon servo double arms from readyheli.com to help you with setting up the servos, dont do what I did and order the wrong ones, they have both the offset and the non offset ones.

[Finless]

Good point! Yes the CNC elevator bell crank is not offset. So if you upgrade you MUST change the elevator servo wheel to also NOT be offset!

Now you could leave the fronts offset or as aaronmatlo says move one ball so the fronts are not offset. If I was building NEW I would go with all not being offset. Much easier to set up that way. But since I upgraded I did not change the fronts (lazy me).

Bob