Axe CP speed control setup and motor question

[emb145pilot]

Hello. I have a Axe CP and I blew the controller board.. Got a replacement for it. When I took the old board out I thought that I had diagrammed it enough so that when I put the new one in I would have all the connctions correct.. Well, needless to say my diagramming wasn't so hot and I am not sure where all the pugs go into the receiver.. I messed around with it for a while and actually got all three servos hooked up and they seemed to be moving in the right fashion. Same with the tail motor. But the motor does not respond to throttle inputs. It does spin up every three seconds for just a second then it quits again. It will surge like this up and do without any input from the controller. Does anyone know what may be causing this and how to fix it? Additionally if anyone has a diagram of how to correctly set up the plugs or know where one is online that would be great.

Thanks for the help!
E.

[emb145pilot]

Please note... I found a setup post a couple minutes after posting this.. So the board is setup correctly.. I think, however, the motor still surges.. And I need to correct something in my first post and that it the motor does not throttle up (start/stop surging) until the control stick on the tramsmitter is moved up from full the full stop position.

Again thanks for the help!