9CHP midstick not equal to 50%

[windbender]

Hope someone can help me on this, the manual seem to be of no help. If I set up a pitch curve in normal mode all five points at 50%, I would expect the graphics to show a straight line, the same as the horizontal reference line to the right of the percentage values. What I end up with, is that the end values are at the midpoint , the 25% and 75% are a little bit higher and the midpoint is slightly higher than those. Instead of getting a straight line , I end up with a peak. To get a straight line, instead of
P/C: 50, 50, 50, 50, 50 it has to be 50, 45, 40, 45, 50. Is there another value in the radio that would affect only the pitch curve in NORMAL mode but not in Idleup modes., Its driving me nuts!

Thanks for your help
Wb

[MrMel]

Dont know about the 9CHP right off the bat, but does it have a hover-throttle/hover-pitch slider? that could it then, it would only apply on normal.

[windbender]

Hi MrMel,
You are exactly right, I set pitch curve to 50% and surely enoughy, as I fooled with the VR(A) knob it corrected itself. I have to go and read up on this now, Thanks a million!!

Wb
p.s the fastest answer i've ever received. this forum rocks!

[BarracudaHockey]

HOV-PIT and HOV-THR

Just disable them both and set High/Low pitch to Manual and Null that screws with the top and bottom like HOV-PIT messes with the middle point.

[windbender]

thanks a lot Barracuda, will do.
Wb