cgalavis
08-11-2007, 09:50 PM
Hi,
I recently installed the 140 swashplate on my ERaptor 620, but I can not get it to work right. I have a JR9303 radio and have set up the swash type to 140, but when I move the elevator up and down, the two side servos (aleron, pitch/aux1) are not moving at the same rate. This does not happen if I set the swash type to 120. I have follow the instructions on the manual and I have checked them several times, it all seems to be correct. The travel on all the servos is the set to the default 100%.
Cheers,
Carlos Galavis
I recently installed the 140 swashplate on my ERaptor 620, but I can not get it to work right. I have a JR9303 radio and have set up the swash type to 140, but when I move the elevator up and down, the two side servos (aleron, pitch/aux1) are not moving at the same rate. This does not happen if I set the swash type to 120. I have follow the instructions on the manual and I have checked them several times, it all seems to be correct. The travel on all the servos is the set to the default 100%.
Cheers,
Carlos Galavis