14MZ never exits display calibration screen

[poerqwa]

Hi,

When I received my 14MZ (more than a year ago) I calibrated the screen.

I noticed some discrepancies in the calibration so I thought to just recalibrate it.

When I start the procedure I can push the crosshairs and it move happily over the screen but when the 5th (first center, bottom right, top right, top left and bottom left) is pushed the crosshair moves to the center to simply start over again(i've tried it for 4 complete cycles before accepting my defeat :noteworthy :lol:)

I've the latest software downloaded from Robbe's support site (dated somewhere in july).

Anybody experienced this and is there a resolution?

regards,

Marc

[alex.venom]

I had a handheld that used to do that. It was pretty boring having to do it again and again, but at the end it works.
As I understand, if the screens does not get the exactly center of the cross, it will start the calibration again.
Try to aim in the very center using the stylus instead of finger. May work. ;)