ryanhal0
08-15-2007, 02:04 AM
I just recently realized that my pitch curve on my CP2 is way off I think.
When I throttle up with the motors disconnected, the servo arms hardly move down at all! maybe 3-5 millimeters!! I could swear last time i fiddled around with it, it had much more play in the throttle/pitch curve than that!!
when I'm at full throttle, my blades have nearly 0 pitch on them, but the servos arent pushing the swash near enough far down at all to make positive pitch!
I'm using it with stock tx/rx and motor/servo/4in1
I do have a brand new cnc head on it - but that shouldnt make the swash move up/down less!!
I can't figure it out!! please help!!
When I throttle up with the motors disconnected, the servo arms hardly move down at all! maybe 3-5 millimeters!! I could swear last time i fiddled around with it, it had much more play in the throttle/pitch curve than that!!
when I'm at full throttle, my blades have nearly 0 pitch on them, but the servos arent pushing the swash near enough far down at all to make positive pitch!
I'm using it with stock tx/rx and motor/servo/4in1
I do have a brand new cnc head on it - but that shouldnt make the swash move up/down less!!
I can't figure it out!! please help!!