View Full Version : Freya X-spec setup for 3D ??'s
04-13-2004, 02:40 AM
Any hint's, tips and opinion's on how not to cut off my tail boom?
- Lower main shaft hole, check.
- red locktite on the damper bolts.
04-13-2004, 05:31 AM
Carbon Extreme dampners or o-ring kit. From what I've been reading, these two items really help cut down the possibility of a boom strike. Of course being too aggressive on the cyclics during piroflips also don't help the boomstrike issue either :)
01-29-2005, 02:45 AM
Don't mean to hijack, but was wondering which setting people are using, standard or high mobility?
When I tried the high mobility setup, I found the freya to be very pitchy. The cyclic rates were extremely quick, but anytime I went into FFF, it would ballon up on me. Presently using standard setup now but curious to go back to high mobility to see if I can cure the problem.
01-29-2005, 07:07 AM
Hey whats up? Nothing really nescesary! It flies good stock. The dampners are definatly good to have though. V2 version is awesome. Just dont run any blades over 690mm. As far as setup I use the standard. Just mess with the weights if you need more response.