TT ESC, Logictech 2100, Futaba S3154 gets hot!

[husafreak]

Hi, I can't set up my E325, every time I plug in the Futaba S3154 tail servo to my gyro the servo and TT speed controller get hot and shut down if I don't sooner. I have tried every different setting on the Logitech but they all get hot, linkage is free, I have lots of experience but this has got me down. I have checked the ESC programming but that doesn't seem to be a factor. Has anyone had this problem?

[cybernero]

Hello.

Are you using D-BEC or BEC seperatly?
Check bec current of your speed controller.
IMO, maybe lack of bec current for controlling gyro and servos.

Think about the BEC system.

Good luck.

[brovic777]

Hi, I can't set up my E325, every time I plug in the Futaba S3154 tail servo to my gyro the servo and TT speed controller get hot and shut down if I don't sooner. I have tried every different setting on the Logitech but they all get hot, linkage is free, I have lots of experience but this has got me down. I have checked the ESC programming but that doesn't seem to be a factor. Has anyone had this problem?

It gets hot because its overloading its motor to run on the mini-titan tail.You might try the s9257 digital servo as its a match made in heaven with the LTG-2100T!!!