Guide to neat wiring?

[Torq]

Is there a post or video that explains the basics and tricks to component and wiring layout?

I've seen "fishnet" covering that goes over wires, but what I have found in hobby stores looks to small to fit servo connector through, so don't get how it is used.

I have also seen a spiral wrap used in pictures, but the only similar thing I can find is at Radio Shack, and is way to big of diameter to be useful.


Thanks!
Torq

[hamslice]

the "fishnet stuff" will stretch over the connectors and when pulled tight will shrink back down. it also helps to protect the wires.

[Skiddz]

The wire braid expands when you compress it. The easiest way to get it on the wires is to use an X-Acto knife to release the pins from the connectors, pull 'em out and then slip the braid on. Finish off each end with a piece of heat shrink and then snap the pins back into the connectors.