Rotorworkz G-10: can't square the frames!

[jackheli]

I am having trouble closing the frames. Every time I start bolting the bearing blocks the frames start to go crooked. Always to the same way...

I have the mast on and I am assembling on a flat surface.

I tried starting from every possible bolt, going squared or cross-wised...

Any tips?

[jackheli]

Ok...

this is what worked:

After every bolt screwed in grab the frames, one on each hand, and twist them in the right direction, aligning them back flat again.

Didn't seem to have this problem with my previous Align frames...:(