Stratus clunk line (new tank)

[chrisg3]

Hey Freaks,
I was curious what lenght clunk line you were using in the new Stratus tank? The manual says to initially cut it to 75 mm, however I've had problems with it getting stuck during inverted flight. Currently, I cut it down to where it just barely hits the left side of the fuel tank (probably 60mm or less).
Thanks,
Chris

[MrMel]

Are you using the supplied clunk line? (thin, soft version)?
With that I had no problem running 75mm

[DavidH]

It would depend on where you installed the fitting in the tank. If you installed the fitting where stated in the instructions. Then the length of the clunk line listed in the instructions should work. Provided you have the line slid all the way onto the nipple inside the tank.

David

[Knud Pedersen DENMARK]

I have installed the fittings as descreibed in the manual (version 1.4).
I'm using the original tank fuel line, leght 72 mm.

Using fuel magnet.

ChopperKnud

[christoffer]

I've had a lots of problems with the clunk line in the new tank with fuel magnet,
either its to long and gets stuck so engine cut, or its to short making the engine go lean,
espacially after doing chaos for long time.
So i made a realy long clunk line about 120mm an used a regual clunk and sub tank, that
made all the problems go away.
It doesn't seem to be the same problem with the old tank.

//Christoffer