Non responsive servos

[Black hawk Down]

I have the 2n1 set up. Today I noticed the rudder response slow then almost vanish, also, the throttle servo was jumping all around and had to ill the engine. No problems when the engine is off, but when fired up
the issues ocur. any Clues? thanks

[BarracudaHockey]

What servos, governor, gyro are you using? Tail rotor servos only like 5 volts or so and running some servos on 6v with high frame rate devices like the csm governor and or a gyro is bad ju ju.

[Black hawk Down]

Governor, Futaba GV-1
F servo s9256
GY 611 Gyro

[scottc]

black hawk check to see if you have any bare wires from rubbing on any metal, like the clutch bell or the start coupler, a few folks had this happen to them.

[WillJames]

Bad bearing in the motor or clutch stack?

[trex600crasher]

I suggest buying a Stratus! Just kidding of course bud. Good luck with the diagnosis.