Raptor Blade pitch setup problem, help please

[modtek]

Hi Guys, im new to heli's and am currently finishing off a raptor titan,

Im having problems with setting up my pitch on my raptor titan.

I put my pitch gauge on 1 of the blades and set it to 0 degrees on centre stick.

then without rotating the blades, i then move onto the other side of the heli and put my pitch gauge on the other blade and it reads + 2 degrees.

Now if i rotate that blade over to the side that i originally measured the first blade it will read 0 degrees.

so when my blades are rotating to 1 side of the heli my pitch is increasing by 2 degrees then comming back 2 degrees on the other side.

I have watched all the setup videos and cannot figure out why this is happening?

Any help will be greatly appreciated,

thanks...

[capebob]

Most likely your swash plate isn't level.
Bob

[OHIOBOWHUNTER]

i'm with cape bob on this...make sure your swash is level when you do your pitch setups (i always have my radio on in case i bump anything it reverts back to level ) also if you don't have a reliable method to level your swash during the radio setup here's how i do it...just a couple square piece's of square wood stock under the swash and ontop of the frame...mine measure about 7/16 in. , size probably not as important as the two being the same size..hope this helps !!