Dwntyme
09-11-2007, 11:34 PM
increased by more than half.
I saw this idea on youtube where a guy (Dave I think it was) took solder and wrapped it around the tail motor for a heatsink, well I took .050 solder tacked one end then wrapped around 2 times tackhed it, then 2 more turns then tack
the end then took the existing sink stretched it out alittle to snap it on. works great tail doesn't get as hot as it used to.
I saw this idea on youtube where a guy (Dave I think it was) took solder and wrapped it around the tail motor for a heatsink, well I took .050 solder tacked one end then wrapped around 2 times tackhed it, then 2 more turns then tack
the end then took the existing sink stretched it out alittle to snap it on. works great tail doesn't get as hot as it used to.