Gyro Sens For the DX7

[burke.bill]

Hi guys I have a setup question with the Gyro sens menu.

The following is what my gyro sens shows. (Auto Rate 0 on both) Fmode (N0 ST0 Hold0)
The reason rate for both is 0 is because when I input rates for gyro sen it does nothing with the gyro on the Raptor 50. I have to goto the travel adj screen and adj the sens for the gyro by adj aux2 travel adj there. So why is that? This is my INPUT SELECT menu

Aux2 Gyro Gear Aux2 maybe not set right here?

Also if one of you fine guy can tell me what I have wrong and then get it right, will a put the travel adj for aux2 back to 100? and then set the number for travel adj into the Gyro Rate 1 and 2?

Hope this makes sense cause I'm having trouble making sense of all this to myself. Getting old I guess. I'm 53 and that's my excuse Ha...And I'm sticking to it..... Thanks Bill

[joehelicopter]

Hi guys I have a setup question with the Gyro sens menu.

The following is what my gyro sens shows. (Auto Rate 0 on both) Fmode (N0 ST0 Hold0)
The reason rate for both is 0 is because when I input rates for gyro sen it does nothing with the gyro on the Raptor 50. I have to goto the travel adj screen and adj the sens for the gyro by adj aux2 travel adj there. So why is that? This is my INPUT SELECT menu

Aux2 Gyro Gear Aux2 maybe not set right here?

Also if one of you fine guy can tell me what I have wrong and then get it right, will a put the travel adj for aux2 back to 100? and then set the number for travel adj into the Gyro Rate 1 and 2?

Hope this makes sense cause I'm having trouble making sense of all this to myself. Getting old I guess. I'm 53 and that's my excuse Ha...And I'm sticking to it..... Thanks Bill
Go to Finless Bobs Tech room and check out Jermo's set up for the DX7 and the gyro:thumbup:

[burke.bill]

Yup did check out Jermo's set up for the DX7 and other than having the gear set to aux2 when it should be set to gear gear. I just don't understand how this would change having to set up the gyro gain in travel adj? Just trying to understand....

[nzreg]

Hi Bill,
I am 65 so age is no excuse :lol:
I used the AUX2 switch set to AUX2 then set the % in the end point menu, works like a charm.