ExBritFlyer
09-13-2007, 02:09 PM
I am re-building my head using the HeliMax Aluminum parts and am a bit confused about the screws attaching the seesaw to the hub.
I only seem to have one in the (HMXE8609 Center hub with bearings.)
Surely there should be one on either side of the hub?
Can anyone tell me what screws/washers/stand-offs etc. should be used here?
Thanks!
I only seem to have one in the (HMXE8609 Center hub with bearings.)
Surely there should be one on either side of the hub?
Can anyone tell me what screws/washers/stand-offs etc. should be used here?
Thanks!