mayday
04-13-2004, 09:15 PM
Has any one installed the radio tray supports and if so where did you bolt them??? Thanks.
Centurian
04-14-2004, 02:42 AM
They are a "Y" shape... the bottom of the "Y" goes to the front of the servo frames where the front inner to outer frame spacers are located. The short leg of the "Y" goes the existing hole in the tray. The long leg of the "Y" ends up at the end of the tray and requires the tray to be drilled at this location.
Hope this helps,
Doug Adams
Century Helicopter Products